Lamp replaced by "DIY Ambilight"

LED strips

Even in full daylight and the LED strips @ 50%, this already looks VERY OK to me! Can’t wait till it’s dark outside..

After some small tests during the last couple of weeks, it was time to finish replacing a lamp near the TV with LED lighting. It’s still a big cable mess in the corner where the TV is located, but you can’t start cleaning up when you’re not finished, right? A lamp, holding 2 energy saving light bulbs, consuming 11W, has now been replaced by LED strips attached to the back of the TV. I call it my “DIY ambilight” project πŸ™‚

The following components were used:

  • 1 x JeeNode v4;
  • 2 x MOSFET Plug;
  • 3 meters of warm white LED strip;
  • XBee series 2 module;
  • XBee breakout board;
  • 3.5 mm mono plugs;
  • 12V power supply.

And 3 x software; 1 for my Home Automation system, 1 for the JeeNode and 1 for the Touchscreen. The Pronto will follow soon.

From my Home Automation system i can control each of the 4 segments individually; i created a new device type and when i send a “L=30” command to this device, the LED strip on the left of the TV goes to 30%. When i send a “B=0“, the bottom LED strip goes to 0%. A “*=10” will result in all 4 LED strips to go to 10%.

The hardware (power supply, JeeNode, LED strips) is controlled by a PLCBUS appliance module, so when it’s time to go to bed, i don’t have to worry about additional standby power usage.

On the Touchscreen i added a popup form so i can change the settings of the LED strips:

TV LED control

Although I’m technically able to, i didn’t put 4 trackbar controls on this form to control each LED segment individually. The reason for that is that I don’t think it will ever be used by anyone else but myself. I think, in daily practice, these 4 LED strips will only be switched on and off, once a brightness level has been set that suits the ligthing in the rest of the living room.

The sketch that is running on the JeeNode is pretty straight forward, once you’ve seen Jean Claude Wipplers sketch to control RGB strips. I think it’s needless to say that without his hardware, software and sharing of knowledge, i would probably still be watching blinking LEDs… well, sort of πŸ™‚

Well, anyway, here it is.

Curious about how the back side of the TV looks right now? Here you can see where the LED strips are attached to the back side of the TV and where i placed the 12V adapter and the enclosure that holds the MOSFET plugs, JeeNode and XBee.

Once i had it all (more or less) figured out, it took me 2 afternoons to go from a cardboard test setup to what it is now. Based on the response from wife and children, this is the best thing that has happened since the introduction of the touchscreen. Which I implemented 18 months ago… πŸ˜• And what has happened to that $$$ Roomba???

Update:

Power consumption? The LED strips provide enough light @ 16%, resulting in a total of 2W power usage. Not bad!

Tagged , , , , . Bookmark the permalink.

3 Responses to Lamp replaced by "DIY Ambilight"

  1. Pingback: A new challenge

  2. Apo says:

    Hello, but how you connect it to tv ? Thank you.

Leave a Reply

Your email address will not be published. Required fields are marked *